Comes as a complete kit (except for tools). Four 16" 1/2 by 1/2 compression water supply lines are provided. Two connect from the water supply valves to the inlets of the Stepflow valve body. The other two connect from the Stepflow valve body to the 1/2" faucet connections of the sink. Typical water supply lines provided fit 1/2" compression water supply valve (from wall). Check if the supply valve outlets are 1/2" NPT. They could also be 3/8" or 7/16"NPT. If so, alternate hoses are available upon request. Illustrated instructions are included.

Tools Required:

1. Slip joint pliers and / or undersink plumbing wrenches.
2. Phillips #2 screwdriver.
3. Drill motor
4. 1/2 inch drill bit for wood.
5. 18 inch length of coat-hanger or wire to bend.

Valve housing mounts to or near back wall. Has actuator cable (like a bicycle brake cable)attached that goes to pedal.

Floor Pedal (Model 200):

A 1/2"hole is drilled through the cabinet floor at the rear of the cabinet and one in front toe board. Cable is installed beneath base of cabinet. Pedal sits on floor and cable is passed through the two holes to reach valve housing.